User's Manual

19
Trouble Shooting
Problems Solutions
1. No power
- Unit is turned off.
- Check if the batteries are installed properly.
- Make sure the adaptor is connected to the Unit
properly if using the adaptor instead of batteries.
- The Unit may be in low battery status, change new
batteries.
2. No sound signal
- Volume level on Parent unit is set too low. Adjust it to
higher volume.
- Sound sensitivity level of Baby unit is too low, turn the
sound sensitivity switch to “HI” position.
- Units are out of range or lost connection. Ensure the
distance between the units within communication
range.
Note: Communication range varies depending on
surrounding conditions such as physical obstructions,
interference.
- Make sure the TALK Button of Parent unit is not
pressed.
- Make sure the unit is unlocked.
- Ensure both units have already linked successfully.
3. Received
Conversation or sound
from neighbors
- Signal interference due to other nursery monitor on
the same ID Code or cordless phone used.
- Change both units to another ID code by pressing
LINK Button.
4. Hearing static or rustle
from Parent unit
- The both units are positioned too close to each other.
Keep not closer than 1 meter/3.5 feet.
- The volume is set too high. Lower the volume at the
Parent unit.
- Replace batteries.