User's Manual

Galaxy G1 
- 39 -
of impact on the GPS signal reception and emission of radio signals.
1) The receiver is set to the base station with external radio mode;
2) Set up tripods, the tripod on which to put the radio antenna should be placed
at a higher point, the least distance between the two tripods should be 3metres.
3) fix the base and the base station receiver, (if set at a known point, a strict
leveling should be done), power on the base station receiver.
4) Install the radio transmitting antenna, hang the radio on the tripod, place the
storage battery at the bottom of the radio station.
5) Connect the radio, mainframe and battery with the multi-function cable,
which is a "Y"-shaped cable used to connect the base station mainframe (5-pin
red jack), transmitting radio (black jack) and external battery (red and black
clip).Playing the role of power supply and data-transmission.
Important:
Please check the red dot on the five-pin port when you use the multifunction
cable, aligning the red dot with the red mark on the mainframe will help it insert
easily. Follow the same instruction when connecting to the radio.
§3.2.2 Start the base station
The first time you start the base station, you need to set the start parameters, set
as follows:
1˅Connect to the base station with EGStar in the handheld (Refer to §2.2.3)
2˅Operation: Configuration → instruments → Base Station (the mainframe
should be in base mode)