User's Manual

Instructions

Remote Record Triggers

Press (REC) on your controller to toggle Recording mode ON or OFF

Recalibrating your Controller

Rotate the focus ring clockwise to the end; hold (SET) + CODE + (REC) buttons together for 3 seconds.

Rotate to the opposite end and press the three buttons again.

Manual Calibration

Specifically used with infinity lenses that have no start or end point. Press the SET and REC button on the

wireless controller together for 3 seconds, and you will see the A, B, C, D lights turn on. Then use the (C)

button or (D) button to control the motor (Hold down the C or D key for more than 3 seconds it will

automatically rotate clockwise or counter clockwise.) Once it rotates to the proper position, click the (A)

button as a starting point, the gear will spin the opposite direction. Then when you find the desired end

point press the (B) button. Finally the (A, B, C, D) four buttons lights turn off to indicate the calibration has

been completed. After the lens calibration, the swivel will automatically shorten the distance for a slight

amount to avoid the noise of the motor stopping.

Blackouts

The controller and motor are able to store data in case of a sudden power loss or battery replacement. The

data from your shoot/lens calibration is saved and the operation can continue once the power is turned

back on. If the drive or Lens has been dismantled or replaced, or the corresponding position of gears has

been changed you will need to repeat the calibration.

Buttons and Lights

When blue (SET) and (COM) lights flash regularly at 3 times / sec, indicates

that it is communicating properly.

• The (SET) light stays dark when connection failed due to long distance, signal break or initialization

failure.

• SET＋A (click for 3 sec) automatic calibration

• SET+ O (click for 3 sec) push to synch controller to motor

• REC (single click) record／pause

• SET＋REC (click for 3 sec) manual calibration

• A,B,C,D (single click) move to the pre set focus point

• A, B, C, D, click for 3 sec, press and hold any one of them to set your focus point. The lights on all

four buttons will flash to indicate the preset has been saved.

• Once the preset has been set, push any of the lettered buttons. The indicator lights for A, B, C, or D

will turn on, it means their positions are being used, push another lettered button to move to that

point or push the one that is already lit up to return to manual mode.

• If the (COM) light on the motor is not on, it indicates that the controller is out of the range or there is

no power.

• The (COM) button on the motor is also used as an indicator. Pushing the button for 3 sec will turn

the blue light to green to signal you to connect to the controller. During normal operation, a single

push of the C-Code button can change the direction of the gear. The color of the light will change

with the direction of the gear.