User's Manual

Controller Description

(1) Code (C) Button

This button synchronizes the Pegasus with the controller, and turns on the collision protection.

Turning On the Collision Protection

The collision protection is off by default; to turn it on, simply hold code for three seconds

Synchronizing the Controller with the Body of the Pegasus

Attach a battery to the Pegasus and press the ON toggle on the side of the Pegasus housing.

Press the CODE button on the side of the Pegasus: the blue COM light on the Pegasus should now

be off. If the light is on, press the CODE button again to turn it off.

Press and hold the CODE button on the controller: the controller will say SEND ADDRESS...SUCCESS

if successful.

If synchronization fails, press the CODE button on the Pegasus so the blue light is off and try holding

the CODE button on the Cinegears controller once more. Synchronization only needs to be done once,

unless other controllers are used.

(2) OFF/MANU/AUTO Toggle

Manually switch between Off (power on/off), MANU (manual mode), and AUTO (automatic mode).

(3) Manual Mode

Allows the user to manually control the slider motion and speed. Manual mode is comprised of three

adjustable parameters (see "Arrow Buttons" to learn how to adjust on-screen parameters):

Adjusting the Parameters of Manual Mode

Run Dir: Controls the motion direction. L means it will travel leftwards; R means it will travel rightwards.

Max Speed: Controls the speed parameters of motion. 0% is a very slow, restricted motion; 100% is

unrestricted.

Press Time: How long you have to hold the Start Button to unlock the ability to cease recording. If it is

set to 3 seconds, you have to hold the button for 3 seconds and then let go: now you can press the

Start Button to cease filming.

(4) Automatic Mode

Allows the user to establish programmable motions and speed of movement over determined durations

of time. Automatic mode is comprised of 6 adjustable parameters, and 2 inventory categories

Adjusting the Parameters of Automatic Mode

Start Place: Controls where the motion starts along the track. Set anywhere between 0-60,000 mm.

Stop Place: Controls where the motion stops along the track. Set anywhere between 0-60,000 mm.

Press Time: How long you have to hold the Start Button to unlock the ability to cease recording. E.g.,

If it is set to 3 seconds, you have to hold the button for 3 seconds and then let go: now you can press

the Start Button to cease filming.