Installation Instructions

There is requirement that the grantee provide guidance to the host manufacturer for
compliance with Part 15B requirements.
The module complies with FCC Part Part 02, 22 H, 24 E,27, 90S and apply for Single
module approval.
Trace antenna designs:
（OHMS）
OHMS with tolerance
Line width(mil)
length（mil）
4G1_MAIN
50
±5
12
1422
4G1_DIV
50
±5
12
1250
The device must be professionally installed The intended use is generally not for the
general public.It is generally for industry/commercial use.The connector is within the
transmitter enclosure and can only be accessed by disassembly of the transmitter that
is not normally required. the user has no access to the connector. Installation must be
controlled. Installation requires special training This module has been assessed against
the following FCC rule parts: CFR 47 FCC Part 02, 22 H, 24 E,27, 90S,( PCB) It is
applicable to the modular transmitter。
This radio transmitter FCC ID: 2A46G-EG25-G has been approved by Federal
Communications Commission to
operate with the antenna types listed below, with the maximum permissible gain
indicated. Antenna types not included in this list that have a gain greater than the
maximum gain indicated for any type listed are strictly prohibited for use with this
device.