Installation Instructions

Notice to OEM integrator

Must use the device only in host devices that meet the FCC RF exposure category of

mobile, which means the device is installed and used at distances of at least 20cm from

persons.This transmitter must not be co-located or operating in conjunction with any

other antenna or transmitter.

The end user manual shall include FCC Part 15 compliance statements related to the

transmitter as show in this manual(FCC statement). Host manufacturer is responsible

for compliance of the host system with module installed with all other applicable

requirements for the system such as Part 15 B, ICES 003. Host manufacturer is strongly

recommended to confirm compliance with FCC requirements for the transmitter when

the module is installed in the host.

Must have on the host device a label showing Contains FCC ID: 2A46G-EG25-G，

The use condition limitations extend to professional users, then instructions must state

that this information also extends to the host manufacturer’s instruction manual.

This module is stand-alone modular. If the end product will involve the Multiple

simultaneously transmitting condition or different operational conditions for a stand-

alone modular transmitter in a host, host manufacturer have to consult with module

manufacturer for the installation method in end system. Any company of the host device

which install this modular should perform the test of radiated &condicted emission and

spurious emission etc. according to FCC Part Part 02, 22 H, 24 E,27, 90S, 15B class B

requirement, only if the test result comply with FCC part Part 02, 22 H, 24 E,27, 90S,

15B class B requirement. Then the host can be sold legally.

This modular transmitter is only FCC authorized for the specific rule parts ( 47CFR Part

Part 02, 22 H, 24 E,27, 90S) listed on the grant, and that the host product manufacturer

is responsible for compliance to any other FCC rules that apply to the host not covered

by the modular transmitter grant of certification. Host manufacturer is strongly

recommended to confirm compliance with FCC requirements for the transmitter when

the module is installed in the host.

Must have on the host device a label showing Contains FCC ID: 2A46G-EG25-G