User's Manual

TagExciterInstallationManual 07‐00051‐110

©
2010GuardRFIDProprietaryandConfidential
Default–Radioactivated–(Note:theAtGuardsystemdoesnothavearadioboardon
theTEandwillshipdefaultedas“radiodeactivated”)

 Pressselectwhileinmodesettingconfigurationuntilthereadoutreads“1”
 PresstheINCkeytotoggleactivate/deactivatetheradio.Theradio
isactivatedwhen
thedecimalpointafterthedisplayislit,deactivatedwhenthedecimalisoff(theMOD
LEDwillflashwhenthesettingisbeingadjusted)
 PresstheENTkeytosavetheselectedvalueinTEmemory(theMODLEDwillstop
flashing)

SettingtheTE
todetectEOL(endofline)Resistors(MODE“2”)
Default–EOLresistorsnotinstalled

 Pressselectwhileinmodesettingconfigurationuntilthereadoutreads“2”
 PresstheINCkeytotoggledetect/ignoreEOLresistors.EOLresistorsaredetectedwhen
thedecimalpointafterthedisplayis
lit,ignoredwhenthedecimalisoff(theMOD
LEDwillflashwhenthesettingisbeingadjusted)
 PresstheENTkeytosavetheselectedvalueinTEmemory(theMODLEDwillstop
flashing)
ReadingtheErrorCodes
IftheAlarmLEDisflashingtheTEhasdetectedanerror.ErrorcodesarereadfromtheTEdisplay
Toreadtheerrorcodes
 Pressanykeytoactivatetheuserinterface
 PresstheSELkeyfourtimes,oruntiltheERRORLEDislit
 Readthe
display:
0–Noerror
1–Caseopen/tamper.Tosimulatethecoveronholdyourhandatthelevelofthe
cover,nearthecentreoftheTEandthe“1”errorshouldstop.Sincethecaseisopen
whentroubleshooting,thiserrorisalwaysdisplayed.You
mustsimulatethecoveron
tocontinue.
2–Radionotdetected.Theradioboardisfaultyornotinstalled(Note:IntheAtGuard
systemthereisnoradioboard)
3–Inputpowertoolow.Checktheinputvoltage;itshouldbe12–13.6VDC
4–Inputpower
toohigh.Checktheinputvoltage;itshouldbe12–13.6VDC
