Installation Instructions

PX/QX/RX Version 4.30 Installation Manual – Issue C
- 4 -
STATUTORY REQUIREMENTS
Hereby Guardall declares that the RX16i, QX32i, PX48i and the PX80i are in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC.
If you have any doubts concerning the suitability, connection or uses of this apparatus then consult a
suitably qualified person before continuing.
SUITABILITY FOR USE
The apparatus has been designed to work on all European analogue networks and has been
independently tested to TBR21. It provides the following facilities:
1. Alarm transmission and transmission/reception of configuration data.
2. Automatic Call Initiation.
3. Series connection.
4. Dial tone Detection
5. Automatic dialling using DTMF tones.
6. Automatic Call Answering.
7. Stored number dialling.
8. Timed Break Register Recall.
It is not suitable for connection to PABX systems or for use as an extension to a payphone.
EN50131 & PD6662 Compliance
PX, QX and RX are suitable for use in systems designed to comply with PD6662:2004. The grade and
class of each variant is shown in the table.
Variant Grade Class
RX16i/QX32i 2 II
All PX 2 or 3 (Programmable) II
Refer to the reset options in the engineer programming manual for details on programming the EN
grade.