Installation Instructions

PX/QX/RX Version 4.30 Installation Manual – Issue C
- 43 -
LEDs
Function Colour State Meaning
XiB Comms Green OFF No power
ON Communication error
Slow FLASH Operating normally
Quick FLASH Active
Hook Red ON Line seized
Line monitor Green ON Valid Exchange voltage level present
Quick flash Network search
Slow flash Registered
GSM Status Yellow
ON Active call
Reporting Formats
The available reporting formats for each route is shown in the table.
Route Formats
PSTN GSM (audio) GSM (data)
Contact ID
✓ ✓ ✗
ADEMCO Fast/Superfast Format
✓ ✓ ✗
SIA Level 3
✓ ✓ ✗
CESA (French panel variants only)
✓ ✓ ✗
Speech (if optional module fitted,
v3.21 or later)
✓ ✓ ✗
Audio (if optional module fitted)
✓ ✓ ✗
PS/2 (GSR) - 1200 baud
✓ ✗ ✗
PS/2 (GSR) - 9600 baud
✗ ✗ ✓
SMS (v4.00 or later)
✗ ✓ ✓
DIL Switches
To enable the Dual Comm module to be used with existing panels, the primary and secondary
communicator routes are selected by DIL switch 5. DIL switches 1-4 are reserved for future use.
DIL Switch
5 4 3 2 1
Function
0 0 0 0 0
PSTN is primary route
1 0 0 0 0 GSM is primary route
The primary route is the normal route for all calls.
If the primary route is PSTN then;
• All calls in all formats will be routed over the PSTN network
• If there is a PSTN line fault then all calls will be routed over the GSM network (refer to the
reporting formats table for details)
Note: If the call format is PS/2 and there is a PSTN line fault then the call will be made on the same
number of GSM. This call will fail as the Windsor modem and GSM modem will use different telephone
numbers.
If the primary route is GSM then;
• All calls in all formats will be routed over the GSM network
• If there is no GSM service available then all calls will be routed over the PSTN network (refer
to the reporting formats table for details)