Installation Instructions

PX/QX/RX Version 4.30 Installation Manual – Issue C
- 6 -
Getting Started
In this manual you will learn how to;
• Identify the components of the PX system
• Connect components together
• Make simple configuration changes
If you are new to the system it is recommended that you connect a basic system “on the bench” and
familiarise yourself with programming the panel. Before getting started ensure you have the following
components;
• A control panel
• A LCD keypad
• A few meters of 4 core cable
• A concentrator (optional)
Now follow these simple steps:
• Connect +, -, A and B terminals of the keypad (CN6-XiB) to the panel XiB (refer to the
appropriate diagram in the panel section of this manual for details) using a length of 4
core cable. For simplicity of wiring adhere to the following colour coding;
+ Red
- Black
A Yellow
B Blue
• Set the address of the concentrator to address 1 (DIL switches 1-6 all off (0))
• Connect +, -, A and B terminals of the concentrator (CN2-XiB) to the panel XiB connector
using a length of 4 core cable using the same colour coding as used for the keypad
connections.
• Connect the mains cable to the fused terminal block and apply power.
The keypad address must be set before it can be used on the system. To set the keypad
address, open the case so that the case tamper switch is activated. Press and hold the ? button until
the address prompt is displayed (approximately 4 seconds):
Address = ??


 or ✗
If the keypad has not been addressed then the prompt will be ?? or 99.
Press ✗ to exit address mode without change.
Address = 01
Press 01 to set the keypad address to 1, then press 

 to confirm


 or ✗
00:00 Sat 02 Jan
The keypad will then display the time/date and company name.
Guardall
PX KP Type-n
Version 2.00
If the displayed message is as shown, or no bleep is heard, then the
keypad is not responding so check the bus connections.
The keypad types are:
Description Type
Standard or with proximity reader 1
With 2 EOL circuit inputs 2