Installation Instructions

PX Version 5.0 - QX/RX Version 4.51 Installation Manual – Issue F
- 40 -
Radio Module
The radio module is fitted with 2 PCBs; a RF module and a serial interface for connection to the
control panel XiB bus. The serial interface PCB is multi-function and for operation as a radio interface
DIL switches 6 and 8 must be on and DIL switch 7 off. DIL switches 1-5 are used to select the radio
module address. The diagram shows the Inovonics receiver module (W76067). The Visonic radio
module (W76110) internal layout is similar. Refer to the serial module section for the connection
details.
The radio module type must be programmed. Refer to the radio options in the engineer manual for
more information.
DIL switches 6-8 are
factory set to the radio
module function
Function DIL Switch
8 7 6
Radio 1 0 1
Address DIL Switch
5 4 3 2 1
1 0 0 0 0 0
2 0 0 0 0 1
3 0 0 0 1 0
4 0 0 0 1 1
5 0 0 1 0 0
6 0 0 1 0 1
7 0 0 1 1 0
8 0 0 1 1 1
9 0 1 0 0 0
10 0 1 0 0 1
11 0 1 0 1 0
12 0 1 0 1 1
13 0 1 1 0 0
14 0 1 1 0 1
15 0 1 1 1 0
16 0 1 1 1 1
17 1 0 0 0 0
18 1 0 0 0 1
19 1 0 0 1 0
20 1 0 0 1 1
21 1 0 1 0 0
22 1 0 1 0 1
23 1 0 1 1 0
24 1 0 1 1 1
25 1 1 0 0 0
26 1 1 0 0 1
27 1 1 0 1 0
28 1 1 0 1 1
29 1 1 1 0 0
30 1 1 1 0 1
31 1 1 1 1 0
32 1 1 1 1 1
Radio Repeater
A radio repeater(s) may be added to the system. Each radio repeater should be added as a
transmitter (refer to the engineer manual for details).
Battery Disposal
Disposal of batteries should be according to the local laws and regulations of your region. Contact
your local waste management office for information on battery recycling or disposal.
If you are not able to identify the applicable rules in your area, please check the instructions which will
be available from the battery manufacturer.