Installation Guide

ManualsBrandsGuardian Fall Protection ManualsFall ProtectionGuardian Fall Protection 11160 M-L Seraph Universal Harness

SERAPH UNIVERSAL HARNESS

USE GUIDELINES

These guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed professional, and to check with

your local building inspector or building permit office for approvals and possible variations that may apply.

#11160

www.gibraltarbuildingproducts.com

Hold at dorsal D-ring, and fully inspect

harness. Take the adjustment out of the

front straps located below the chest

strap (increase size of the harness).

Ensure all straps are not twisted and

all buckles are unfastened.

Place harness shoulder straps over

shoulders (like a jacket). Ensure dorsal

D-ring faces out, and is adjusted to rest

between the middle of the shoulder blades

Connect leg straps around thighs. Insert

your hand between the leg strap and your

leg; if you can create a fist, the strap

needs to be tightened. Ensure there is no

twisting of webbing. Leg straps should

never dangle or hang loose.

Attach chest strap and tighten until snug.

The strap should be nipple high. Connect

chest strap. Ensure there is no twisting of

webbing.

Adjust chest, leg, and shoulder straps so

they fit snugly, but still allow for a full

range of movement.

Any twisting of webbing, or straps that are fitted too loose or too tight, can significantly increase the risk of serious

injury or death in the event of a fall.

Donning a harness may require assistance

from another person. We recommend that

another person, with knowledge of the safe

and correct use of the harness, inspect to

ensure the harness is being worn correctly.

1 2 3

4 5

Summary of content (1 pages)

PAGE 1
USE GUIDELINES SERAPH UNIVERSAL HARNESS #11160 Any twisting of webbing, or straps that are fitted too loose or too tight, can significantly increase the risk of serious injury or death in the event of a fall. 1 2 3 Hold at dorsal D-ring, and fully inspect harness. Take the adjustment out of the front straps located below the chest strap (increase size of the harness). Ensure all straps are not twisted and all buckles are unfastened. Place harness shoulder straps over shoulders (like a jacket).