Specification

ULTRA-JACK
SYSTEM
Customer Support and Ordering Information
781-344-1000 • www.qualcraft.com
ULTRA-JACK
INSTRUCTIONS
To Pass an Ultra-Jack Brace:
1) When passing an Ultra-Jack Brace that is already installed,
an extra brace should be installed approximately 4 feet above
the one to be passed until the original brace is reinstalled.
2) After installing the temporary brace, loosen the wing nut and
allow the brace to be passed to swing clear of the pole. Do not
remove from wall. After brace has been passed, reconnect it to
pole and remove the extra brace.
Care and Use of the Ultra-Jack Scaffold System:
1) Prior to use the user should inspect the installation to insure
that the system is properly set up and ready for use.
2) Do not use equipment if wet or frozen.
3) Oil crank handle bushings as necessary.
4) An access ladder shall provide safe access to the work plat-
form.
5) Ultra-Jack Scaffolding must
not be used over 48 feet off the
ground.
6) There should never be more
than two people on an Ultra-
Jack System between any two
poles.
7) Only one walk plank shall be
supported between any two
poles.
8) Additional safety accessories
such as guardrails, mid-rails,
toe-boards, fall arrest or har-
ness systems must be used as
required by OSHA Regulations.
This Product must be used in strict compliance with
Local, State and Federal OSHA Regulations.
Be safety conscious.
Failure to read and follow instructions on the use of this
product could result in serious personal injury.
To prevent an unstable scaffold that could lead to seri-
ous personal injury:
• Use only Qual-Craft® Ultra-Jack™ products as
part of this system. Do not use with other manufac-
turers’ pump jacks, poles or accessories.
• Do not use with wood poles.
• Do not use above 48 feet or with more than two
poles of any length joined together.
• Poles must be secured with rigid triangular steel
bracing at top, bottom and at points in-between in
accordance with instructions.
• Do not use without guardrails, mid-rails, toe-
boards and or fall-arrest system.
•Do not use a workbench as a substitute for the
requirement of a guardrail system.
OSHA requires that the user have knowledge of all
regulations that apply to the use and care of this prod-
uct and that the employer must provide training.
This product must be used in strict compliance with Lo-
cal, State, & Federal OSHA Regulations.
• Inspect all Ultra-Jack equipment before and after
each use. Be sure that there is no damage or defor-
mation to any of the equipment.
• Inspect the rubber surface of the pole before and
after each use for worn or damaged surface, replace
if necessary with Qual-Craft replacement compo-
nents.
• When joining two poles always inspect splices to
insure that there is no gap between rubber surfaces.
Capacity:
Pump Jack scaffolding should not carry more than two
people or 500 pounds between any two poles. This
considers a 4:1 safety factor as required by OSHA Stan-
dards when installed and used in accordance with the
instructions. When used in accordance with instructions
this product meets U.S. Department of Labor OSHA
Regulations