Product Name: Daytona Big Block SRL Part #: 10968; 10967; 10979; 10980; 35189; 35190 Instruction Manual Do not throw away these instructions! Read and understand these instructions before using equipment!
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St.
Trainer: User: Applicable Safety Standards When used according to instruction specifications, this product meets or exceeds all applicable OSHA 1926 Subpart M, OSHA 1910, ANSI Z359.14-2012, and ANSI A10.32-2012 standards for fall protection. Applicable standards and regulations depend on the type of work being done, and also might include state-specific regulations. Consult regulatory agencies for more information on personal fall arrest systems and associated components.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Safety Information ! WARNING Failure to understand and comply with safety regulations may result in serious injury or death. Regulations included herein are not all-inclusive, are for reference only, and are not intended to replace a Competent Person’s judgment or knowledge of federal or state standards. Do not alter equipment. Do not misuse equipment.
Prior to EACH use, all equipment in a fall protection system must be inspected for any potential or existing deficiencies that may result in its failure or reduced functionality. IMMEDIATELY remove equipment from service if any deficiencies are found. Equipment must be inspected by a Competent Person at least every six months. These inspections must be documented in equipment instruction manual and on equipment inspection grid label.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 Repairs to Daytona Big Block SRLs can only be made by a Guardian Fall Protection representative or an entity authorized by Guardian. Contact Guardian for all maintenance and repair needs at: 1-800-466-6385. If a Daytona Big Block SRL fails inspection in any way, immediately remove it from service, and contact Guardian to inquire about its return or repair.
Use of equipment in unintended applications may result in serious injury or death. Maximum 1 attachment per connection point. Personal Fall Arrest: Daytona Big Block SRLs may be used in Personal Fall Arrest applications to support a MAXIMUM 1 Personal Fall Arrest System. Structure must withstand loads applied in the directions permitted by the system of at least 5,000 lbs. Maximum free fall is 2’. SRL may be positioned no more than 2’ below harness dorsal D-ring. Applicable D-ring: Dorsal.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Limitations Fall Clearance: There must be sufficient clearance below the anchorage connector to arrest a fall before the user strikes the ground or an obstruction. When calculating fall clearance, account for a MINIMUM 3’ safety factor, deceleration distance, user height, length of lanyard/SRL, and all other applicable factors.
Two or more snap hooks or carabiners connected to each other. NO. Connector directly to webbing. NO. Two connectors to same D-ring. NO. Incompatible or irregular application, which may increase risk of roll-out. NO. 8 Application that places load on gate. NO. Connector directly to horizontal lifeline. NO. www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 Connector to integral lanyard. NO. 6305 S. 231st St., Kent, WA 98032 Connector closed and locked to D-ring. OK.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 Correct Anchorage Positioning: This chart details allowable working zones required to reduce risk of swing falls and improper side loading. ALWAYS adhere to information specified by chart.
www.guardianfall.com Components and Specifications Materials: High Strength ABS, stainless steel, polyester, and nylon.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Installation and Use Guardian Fall Protection Daytona Big Block SRLs may be used in Leading Edge (LE) applications. Maximum free fall is 2’. ALWAYS avoid lifeline contact with sharp or abrasive edges and surfaces. In Fall Arrest applications, anchorage connection point may be at most 2’ below harness dorsal D-ring. 1.
In the event of a fall over the edge, special rescue measures may be necessary. Always account for use of Daytona Big Block SRLs in job site rescue plan developed by job site Competent Person. X≥90° Leading Edge X≤90° Setback Distance Image 2 www.guardianfall.com Guardian Fall Protection Image 1 phone: (800) 466-6385 fax: (800) 670-7892 NEVER work on the far side of an opening that is opposite the Daytona Big Block SRL anchorage point. 6305 S. 231st St.
www.guardianfall.com Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 phone: (800) 466-6385 fax: (800) 670-7892 Labels 10968 65’; 3/16” CABLE CUSTOM # WARNING: Prior to use, fully read and understand all manufacturer’s instructions provided with equipment at time of shipment. DO NOT ATTEMPT TO SELF SERVICE OR REPAIR! DO NOT REMOVE THIS LABEL. Serial # USE: Always use in accordance with manufacturer’s instruction manual and labels included with this device at the time of shipment.
This inspection log must be specific to one Daytona Big Block SRL. Separate inspection logs must be used for each Daytona Big Block SRL. All inspection records must be made visible and available to all users at all times. If equipment fails inspection IMMEDIATELY REMOVE FROM SERVICE. Guardian Fall Protection Notes www.guardianfall.com Date of First Use: __________________.