Product Manual

14 beamLabs.io 1-800-436-9186
H
G
Photos eyes
should be no
more than 6
inches (15.2 cm)
above the floor.
"MUFS
'MPPS N

CONNECTING PHOTO EYE SAFETY SYSTEM
Look in the box for:
Mount photo eyes. Run wire to head. Use insulated staples to secure
photo eyes’ wire to wall or ceiling. Be careful not to
damage the wires while securing staples.
Cut and discard excess wire. Use small flat head screwdriver to
push in orange tab on the wire terminal, insert 1/2 inch (1.2 cm) of
the wire into the terminal while pushing in the tab. Connect wires
to power head.
* VERY IMPORTANT! *
Strip 7/16 inch (1 cm) of insulation
from the end of the wire.
Each pair of terminals MUST be
connected with one white wire and
one striped wire (non-polarized) from
the SAME accessory.
Door track mounting
Floor mounting
WARNING
To prevent SERIOUS INJURY or DEATH from
electrocution:
• Power MUST NOT be connected until instructed.
• The garage door opener will not operate until the
photo eye safety system is properly connected and
aligned.
• Install the photo eye safety system NO higher than
6" (15 cm) above the floor.
• No part of garage door or other objects should
obstruct the photo eye safety system during door-
closing.
Photo Eyes 4x Screw #12 x 1-1/4"

7/16 inch (1 cm)