Product Manual

16 beamLabs.io 1-800-436-9186
TDSFX
%FMVYF%PPS
$POUSPM
.JOh
BCPWFGMPPS
CONNECTING DELUXE DOOR CONTROL (BU400, BU800)
Look in the box for:
Wire deluxe door control to power
head as shown.
1. Strip 7/16 inch (11 mm) of insulation from wire and separate wires.
2. Connect one wire to each of the two screws on the back of the
door control. **DO NOT USE PRE-EXISTING WIRE**
3. Mark the location of bottom mounting hole and drill 5/32 inch hole.
4 Install the bottom screw and allow 1/8 inch (3 mm) to protrude
from wall. Note: Use anchors if mounting to drywall.
Deluxe Door Control
1st screw
*NOTE: Your opener will contain one of two door controls. Follow the instructions corresponding to the control provided.
WARNING
To prevent SERIOUS INJURY:
• DO NOT connect power until instructed.
• install the garage door opener at least 7 feet
(2.13 m) above the floor.
• Fasten the power head SECURELY to STRUCTURAL
SUPPORTS of the garage to prevent falling.
• If installing brackets to masonry, concrete anchors
(not provided) MUST be used.
Deluxe Door Control* 2x Screw #6 x 1-3/8"
Connect plug from deluxe door control to
wall panel outlet on the back panel of the
power head.
**If using pre-existing wire you may cut off
plug and splice to existing wire**
Using the deluxe door control (ONLY aer programming
has been completed).
Door – Press and release to open/close the door
Light – Press and hold to activate/deactivate motion
sensing security lighting
Vacation Lock
Unlock – Slide lock button to the right to enable all
remotes, door control, and accessories.
Lock – Slide lock button to the le to disable all
remotes, door control, and accessories.
-*()5
6/-0$,
-0$,
4MJEF
Min. 5' (1.52 m)
above floor
2x Drywall Anchors
[New Image]