Product Manual
18 beamLabs.io 1-800-436-9186
Connect the wire from the standard door control to the push button terminal on the rear panel of the power head.
**If using pre-existing wire you may cut off plug and splice to existing wire**
.JOh
BCPWFGMPPS
CONNECTING STANDARD DOOR CONTROL (BU100)
Look in the box for:
Wire standard door control to
opener as shown.
*NOTE: Your opener will contain one of two door controls. Follow the instructions corresponding to the control provided.
WARNING
To prevent SERIOUS INJURY:
• DO NOT connect power until instructed.
• Install the opener at least 7 feet (2.13m) above the
floor.
• Fasten the power head SECURELY to STRUCTURAL
SUPPORTS of the garage to prevent falling.
• If installing brackets to masonry, concrete anchors
(not provided) MUST be used.
Standard Door Control* 2x Screw #6 x 1-3/8"
Min. 5'
(1.52 m)
above floor
Standard Door Control
2x
Screw
6
x
1 3/8
2x Drywall Anchors
[New Image]
1. Strip 7/16 inch (11 mm) of insulation from wire and separate wires.
2. Connect one wire to each of the two screws on the back of the
door control. **DO NOT USE PRE-EXISTING WIRE**
3. Mark the location of bottom mounting hole and drill 5/32 inch hole.
4 Install the bottom screw and allow 1/8 inch (3 mm) to protrude
from wall. Note: Use anchors if mounting to drywall.
TDSFX
1st screw