Product Manual
22 beamLabs.io 1-800-436-9186
Open door using
door control.
CFFQT
VQPO
TUSJLF
FINAL ADJUSTMENTS AND TESTING
1. Open the door by using the door control.
2. Make sure photo eye safety system are aligned with both the red and green LEDs illuminated. If not, refer
back to page
14. Place the garage door opener carton in the path of the door.
3. Keeping the door in sight press the door control or remote control to close the door
Door should NOT move more than 1 inch (2.5 cm) and the garage door opener will beep and flash 20 times.
1-1/2 inch (3.8 cm) solid object
WARNING
To prevent SERIOUS INJURY or DEATH from a
closing garage door:
• The Safety Reversal Test MUST be conducted ONCE
A MONTH.
• NO ONE should cross the path of moving door
during operation and/or testing.
• Aer ANY adjustments to the door system, the
Safety Reverse Test MUST be performed to ensure
the door reverses on contact with a 1-1/2 inch (3.8
cm) thick (2x4 laid flat) object.
• The Photo Eye Safety System MUST be properly
aligned, and tested regularly.
Place a 1-1/2 inch (3.8cm)
flat solid object on the floor,
centered under the garage door.
Use Door Control to close door. Door MUST
REVERSE and beep within 1.5 seconds upon
striking the object, and stop at the fully open
position. Use door control or remote to close
door. Door MUST reverse* upon making
contact with the object.
beeps upon
contact
&NJUUFS
4FOTPS
(SFFO-JHIU 3FE-JHIU
'MBTIFT
0''
CFFQTBOE
SFWFSTFTVQPO
PCTUSVDUJPO
Emitter Sensor
Green LED
Flashes
Red LED
OFF
20 beeps and
reverses upon
obstruction
* If door does not reverse, return to page 17, reprogram the operator, taking care to set the down limit lower than initially.
Verify correct page numbers