Product Manual
2 beamLabs.io 1-800-436-9186
BEFORE YOU BEGIN SAFETY INSTRUCTIONS
To reduce the risk of severe injury or death:
1. READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS.
2. Install only on a properly balanced garage door. An improperly balanced
door has the potential to inflict severe injury. Have a qualified service
person make repairs to cables, spring assemblies, and other hardware
before installing the opener.
3. Remove all ropes and remove or make inoperative all locks connected to
the garage door before installing opener.
4. Where possible, install the door opener 7 feet (2.13 m) or more above the
floor. For products having an emergency release, mount the emergency
release within reach, but at least 6 feet above the floor and avoiding con-
tact with vehicles to avoid accidental release.
5. Do not connect the opener to source of power until instructed to do so.
6. Locate the control button: (a) within sight of door, (b) at a minimum height
of 5 feet so small children are not able to reach it, and (c) away from all
moving parts of the door.
7. Install the Entrapment Warning Label next to the wall-mount control button
in a prominent location. In case the adhesive not adhere on the surface,
the label should be attached to the by mechanicals means.
8. Aer installing the opener, the door must reverse when it contacts a
1-1/2 inch (3.8 cm) high object (or a 2x4 board) laid flat on the floor.
WARNING
Measure door height. Check mounting
locations.
Are additional
reinforcement material
needed?
If over 7.5 feet (2.28 m),
rail extension kit will be
needed.
See page 3
See page 3
Check your toolbox. Do
you have all the tools
needed?
h
7.5 feet
(2.28 m)