Owner's manual

E-6 E-7
1. Separate the tank from the
base of the unit.
2. Flipoverwatertankandopenthe
tank lid, turning it to the left.
3. Pour cool, clean water directly
 intothetank.Donotpouranything
but water into the tank.
4. Close the tank lid, turning it to the right.
 ItisimportanttoFIRMLYsecurecapafter
filling the tank with water.
SET UP
Selectarm,level,atlocation-atleastsixinches(15cm)fromanywallorobjectforproperair
ow.Placethehumidieronawater-resistantsurface,aswatercandamagefurnitureandsome
ooring.Donotplaceunitdirectlyoncarpet,towels,blanketsorotherabsorbentsurfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
FILLING
Make sure unit is unplugged.
DIRECTIONS FOR USE DIRECTIONS FOR USE
8. Select Desired Settings
See”Control Operation” section for available
unit functions. Note: When you power “on”
the humidistat reading range is from 15% to
90%. If the room humidity is below 15%, the
 displayreadingwillash.
%
7. Power Button
 Beforeturningonmakesurethere
is water in the unit. Press the
Power button.
5. Attach the tank to the base of the
unit and plug in.
AUTO
6. Extension Wands
 Ifdesired,assembleextensionwandsby
fitting ends together. Then attach to the
 humidityspout.Thewandswillextend
the mist to a higher level in the air to
help disperse throughout the room.
9. Water Level Window &
Auto Shut Off Feature
The tank includes a water level window so
you can easily see when it is time to refill with
water. The unit will automatically shut off
and a low water icon will blink on the display
panel if the water level is too low. If this
happens, unplug the unit, remove the tank
and refill.
AUTO
%