Owner's manual

E-12 E-13
PROBLEM SOLUTION
Humidifier display not reaching
“auto” or desired humidity level.
There are a few things that can affect the reading.
Theclimate(example-ifinaverycoldclimate,thefurnace will
run frequently, letting dry air into the room).
The room may be too large and may be open to other spaces.
Try warm humidification, sometimes this increases the
humidity faster.
Also, unplugging it for a period of 5-8 minutes. Sometimes it is
possible to overload the unit when first getting the product and
trying out all the buttons.
TROUBLESHOOTING GUIDE
PROBLEM SOLUTION
Water vapor and humidity are
not produced.
Power Plug: Unplug and then try again.
PowerFailure:Whenthepowerisreturned,tryagain.
Tank Installation: Make sure the tank is correctly attached.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
(see pg. E-10)
Air blows but water vapor is
not produced.
ExcessiveWater:Removeacertainamountofwaterfrom
the tank.
The desired humidity is lower than the current temperature:
Increase the desired humidity.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
(see pg. E-10)
If you use hard water, replace with softer water.
Humidity level is low. The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
(see pg. E-10)
The water in the unit is too cold: Replace with cool, but not
cold water.
Damageontheultrasonicdisk:ContactCustomerService
1.866.603.5900
Warm humidity is not produced. It may take 10-15 minutes before warm humidity is created. The
mist may not feel warm due to the fact it is so fine and is cooled
rather quickly from the air in your home. Test by either feeling the
base of the unit which should be warm to the touch or by allowing
theunittorunforapproximately30minutesonwarmsettingin
a closed 200 sq. foot room or smaller. The room should feel
moderately warmer if the unit is working properly.
The humidity has a bad smell. Poor maintenance or dirty water: Clean the product thoroughly, and
fill it with fresh water. (see pg. E-10)
White dust is forming on
nearby furniture.
Hardwatermaydepositacertainamountofdust.Dustintheair
also settles because of added humidity in the room. Use distilled
water if this becomes a nuisance.
*DecalcicationFilter(FLTDC20)availableat
www.guardiantechnologies.com or through Customer Service
1.866.603.5900.
Unit has stopped working. No or low water. Unplug unit and refill tank.
Water is accumulating outside of unit
or area surrounding unit.
Saturation of humidity. Lower mist control setting.
Unit not level and water is accumulating. Unplug and place on
level surface. Point spray away from objects. Raise unit on a
water-resistantlevelsurface2-3feetoffofoor.
Water dripping when refilling.
Cap not tight.
Water remaining on bottom of tank. Wipe tank or tilt to drain
before transporting.
Twist to firmly secure cap after filling tank with water.
Increased noise level. Unitmustbeplacedonaat,level,hardsurface.Makesureitis
NOT placed on a soft or absorbent surface.
TROUBLESHOOTING GUIDE