Product Name: Non-Shock Lanyard Part #: 01121; 01122; 01120; 01280; 01250; 01255; 01260; 01265; 01251; 01261; 01265; 01270; 01271 Instruction Manual Do not throw away these instructions! Read and understand these instructions before using equipment! Introduction 1 Applicable Safety Standards 1 Worker Classifications 1 Product Specific Applications 1-2 Limitations 2-3 Components and Specifications 3 Installation and Use 4 Maintenance, Cleaning, and Storage 5 Inspection 5 Inspection Log 5
Serial #: Trainer: User: Applicable Safety Standards When used according to instruction specifications, this product meets or exceeds all applicable OSHA 1926 Subpart M, OSHA 1910, ANSI Z359.1-2007, and ANSI A10.32-2012 standards for fall protection. Applicable standards and regulations depend on the type of work being done, and also might include state-specific regulations. Consult regulatory agencies for more information on personal fall arrest systems and associated components.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection ! Non-Shock Absorbing Lanyards may only be used in Fall Arrest WARNING applications when used with compatible shock absorber extension. Restraint: Non-Shock Lanyard may be used in Restraint applications. Restraint systems prevent workers from reaching the leading edge of a fall hazard. Always account for fully deployed length of lanyard/SRL.
Two connectors to same D-ring. NO. Connector directly to webbing. NO. Incompatible or irregular application, which may increase risk of roll-out. NO. Connector directly to horizontal lifeline. NO. Two or more snap hooks or carabiners connected to each other. NO. Components and Specifications Materials: Webbing: Polyester and nylon. 1” width. Snap Hooks/Rebar Hooks: galvanized steel or aluminum.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 1. Inspect Guardian Non-Shock Absorbing Lanyards and all PFAS equipment to be used in combination with Non-Shock Absorbing Lanyards. 2. Ensure that all connectors and all other components of the PFAS are compatible with Guardian Non-Shock Absorbing Lanyards, and are selected by a Competent Person. The selected safety harness MUST be of proper size, and MUST be fitted snugly, but still allow for a full range of movement. 3.
When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals, or other degrading elements. Inspection Prior to EACH use, inspect Non-Shock Lanyard for deficiencies, including, but not limited to, corrosion, deformation, pits, burrs, rough surfaces, sharp edges, cracking, rust, paint buildup, excessive heating, alteration, and missing or illegible labels.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Safety Information ! WARNING Failure to understand and comply with safety regulations may result in serious injury or death. Regulations included herein are not all-inclusive, are for reference only, and are not intended to replace a Competent Person’s judgment or knowledge of federal or state standards. Do not alter equipment. Do not misuse equipment.
Capacity: 130-310lbs max. (including all equipment) Material: Polyester or Nylon www.guardianfall.com Follow manufacturer’s instructions provided with this lanyard at time of shipment from manufacturer. Fully read and understand these instructions before using. User must inspect before each use. Competent Person to inspect and initial at least every 6 months. Date of First Use _____________ Product lifetime is indefinite, as long as product passes all inspection requirements. 90396 (Rev.
