Product Name: Rope Anchor Part #: 01300 Instruction Manual Do not throw away these instructions! Read and understand these instructions before using equipment! Introduction 1 Applicable Safety Standards 1 Worker Classifications 1 Product Specific Applications 1-2 Limitations 2-3 Components and Specifications 3 Installation and Use 3-4 Maintenance, Cleaning, and Storage 5 Inspection 5 Inspection Log 5 Safety Information 6 Labels 7
Serial #: Trainer: User: Applicable Safety Standards When used according to instruction specifications, this product meets or exceeds all applicable OSHA 1926 Subpart M, OSHA 1910, ANSI Z359.1-2007, and ANSI A10.32-2012 standards for fall protection. Applicable standards and regulations depend on the type of work being done, and also might include state-specific regulations. Consult regulatory agencies for more information on personal fall arrest systems and associated components.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Restraint: Rope Anchor may be used in Restraint applications. Restraint systems prevent workers from reaching the leading edge of a fall hazard. Always account for fully deployed length of lanyard/SRL. Structure must withstand loads applied in the directions permitted by the system of at least 1,000 lbs. No free fall is permitted.
Components and Specifications Materials: aluminum. Hole #1 Hole #2 Hole #3 Hole #4 Hole #5 Hole #6 Installation and Use Prior to use, plan your system: 1. All PFAS equipment must be selected and deemed compatible with Rope Anchor by a Competent Person. 2. Eliminate or minimize all risk of swing fall. 3.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Rope Threading #1: Front 1. With engravings facing away from user, thread rope end through hole #1, and pull rope through a total of 24”. #6 2. Insert 24” rope end through hole #2 and pull through so there is no slack. PFAS Attachment Point. #5 3. Continue by threading rope end through hole #3 and pull through so there is no slack. #4 4.
When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals, or other degrading elements. Inspection Prior to EACH use, inspect Rope Anchor for deficiencies, including, but not limited to, corrosion, deformation, pits, burrs, rough surfaces, sharp edges, cracking, rust, paint buildup, excessive heating, alteration, and missing or illegible labels.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Safety Information ! WARNING Failure to understand and comply with safety regulations may result in serious injury or death. Regulations included herein are not all-inclusive, are for reference only, and are not intended to replace a Competent Person’s judgment or knowledge of federal or state standards. Do not alter equipment. Do not misuse equipment.
www.guardianfall.com Labels phone: (800) 466-6385 fax: (800) 670-7892 USE 5/8” - 3/4” (16 - 19 mm) OR APPROVED ROPE ONLY ROPE ANCHOR Inspection Grid on back of Anchor. 6305 S. 231st St., Kent, WA 98032 WARNING READ AND FOLLOW MFG’S INSTRUCTIONS P/N 01300 Guardian Fall Protection MADE IN TAIWAN 7 85112 (Rev.
