Item Brochure

Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 phone: [phone] fax: [phone] www.guardianfall.com
Rebar Chain Assembly
Compliant with all OSHA 1910, OSHA 1926 Subpart M,
ANSI Z359.1-2007, and ANSI A10.32-2012 regulations.
Rebar Chain Assembly is suitable for the following applications:
MAXIMUM 1 user per Rebar Chain Assembly.
UPC-A Codes: 01600: 672421016009; 01603: 672421016030; 01605: 672421016054;
01608: 672421016085; 01609: 672421016092; 01610: 672421016108; 01611: 672421016115
Custom configurations not available. Not repairable.
Contact customer service for details.
!
WARNING
Use of equipment in unintended applications may result in serious
injury or death. Maximum 1 attachment per connection point.
Part # Length
Connectors
01600
01603
01605
01608
01609
01610
01611
24”
24”
24”
26”
24”
24”
22”
Standard HS Rebar Hook and HS Snap Hooks
HS Swivel Rebar Hook and HS Snap Hooks
HS Rebar Hook and HS Clevis Pin Snap Hooks
Grade 890 Chain, with HS Rebar Hooks and HS Snap Hooks
HS Rebar Hook and HS Snap Hooks
HS Rebar Hook and HS Clevis Pin Snap Hooks
HS Swivel Rebar Hook and HS Snap Hooks
All Rebar Chain Assemblies are made from 100% steel.
Connect Snap Hooks
to harness shoulder
OR side D-rings.
Rebar Hook fully
closed and
locked around
structural rebar.
Work Positioning: Rebar Chain Assemblies may be used in Work Positioning applications. Work Positioning
systems allow a worker to be supported while in suspension and work freely with both hands. Structure must
withstand loads applied in the directions permitted by the system of at least 3,000 lbs. Maximum allowable
free fall is 2’. Applicable D-rings: Side, Shoulder.
Rebar hook at center of Rebar Chain Assembly must ONLY be connected to
structural rebar. Rebar Chain Assembly snap hooks must ONLY be connected to
applicable harness D-rings.
Guardian Fall Protection recommends that a back-up fall protection system, suitable
for Fall Arrest applications, be used in conjunction with Rebar Chain Assemblies.
Worker capacity range (including all clothing, tools, and equipment): 130-310 lbs.
NEVER use Rebar Chain Assemblies for rigging equipment or as material hoists.
Ensure that 100% tie-off is maintained at all times.
Quick Link Carabiners must only be used to connect Rebar Chain Assembly chain
links for purposes of adjusting length of chain. Both Chain Legs must always be
adjusted to same length. NEVER make any connections to Quick Link Carabiners.
!
WARNING