Product Name: Rebar Chain Assembly Part #: 01600; 01603; 01605; 01608; 01609; 01610; 01611; 21610 Instruction Manual Do not throw away these instructions! Read and understand these instructions before using equipment! Introduction 1 Applicable Safety Standards 1 Worker Classifications 1 Product Specific Applications 2 Limitations 2-3 Components and Specifications 3-4 Installation and Use 4 Maintenance, Cleaning, and Storage 5 Inspection 5 Inspection Log 5 Safety Information 6 Labels
User Information Date of First Use: Serial #: Trainer: User: Applicable Safety Standards When used according to instruction specifications, this product meets or exceeds all applicable OSHA 1926 Subpart M, OSHA 1910, ANSI Z359.1-2007, and ANSI A10.32-2012 standards for fall protection. Applicable standards and regulations depend on the type of work being done, and also might include state regulations if applicable.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 USA Guardian Fall Protection Product Specific Applications ! WARNING Use of equipment in unintended applications may result in serious injury or death. Maximum 1 attachment per connection point. Work Positioning: Rebar Chain Assemblies may be used in Work Positioning applications. Work Positioning systems allow a worker to be supported while in suspension and work freely with both hands.
Two or more snap hooks or carabiners connected to each other. NO. Connector directly to webbing. NO. Two connectors to same D-ring. NO. Application that places load on gate. NO. Incompatible or irregular application, which may increase risk of roll-out. NO. Connector directly to horizontal lifeline. NO. Components and Specifications Materials: Chain: galvanized steel. Web (part #s 01610 and 21610): polyester. Connectors (rebar hooks and snap hooks): galvanized steel.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 USA Guardian Fall Protection 01600 01603 01605 01608 01609 01610 01611 21610 Installation and Use ! WARNING Guardian Fall Protection recommends that a back-up fall protection system, functional in Fall Arrest applications, be used in conjunction with all Rebar Chain Assemblies. Competent Person must make final determination regarding use of back-up fall protection system. 1.
When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals, or other degrading elements. Inspection Prior to EACH use, inspect Rebar Chain Assembly for deficiencies, including, but not limited to, corrosion, deformation, pits, burrs, rough surfaces, sharp edges, cracking, rust, paint buildup, excessive heating, alteration, broken stitching, fraying, and missing or illegible labels.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 USA Safety Information ! WARNING Failure to understand and comply with safety regulations may result in serious injury or death. Regulations included herein are not all-inclusive, are for reference only, and are not intended to replace a Competent Person’s judgment or knowledge of federal or state standards. Do not alter equipment. Do not misuse equipment.
www.guardianfall.com Rebar Chain Assembly Part #: Date of Manufacture: Guardian Fall Protection • 1-800-466-6385 • www.guardianfall.com. Prior to use, read and understand all manufacturer’s instructions. Remove from service if exposed to forces of fall arrest. ANSI Z359.1-07 and A10.32-12; OSHA 1910 and 1926 Subpart M Material: galvanized steel. Weight capacity range (including equipment): 130-310 lbs. Avoid contact with sharp and abrasive edges and surfaces. For Work Positioning applications ONLY.
