User Manual

Guardian Field Support Manual – Section 2
35
Adjusting the Yaw
The Yaw should be set between -20 to 20
degrees of the drivers head position.
Adjust the angle of the ICS (horizontally left
and right) so that the sensor is perpendicular
to the head position as shown in the image.
Important Points to Note:
Ensure the mounting plate is securely mounted to the vehicle so that it will not become a
projectile in the event of harsh braking or impact.
The adjustment screws should be tightened sufficiently to avoid any movement of the mount
during normal vehicle operation. Do not over-tighten the screws as this could damage the
mount.
During the adjustment of the mounting arm it can be ‘soft locked’ to allow static
positioning.Once in the final position it must be ‘hard locked’ by tightening the screws after you
have completed the IVS installation wizard.
Connecting the ICS to the controller
The 3.5m extension cable must be used as it
provides the only connection to the Controller
Unit. Excess cable will need to be neatly
positioned out of the way. Use zip ties to
secure the cable.
Note: The camera cable must be completely
and securely inserted into the processor
during installation. Failure to do so will result in
the absence of LED’s during the imaging
process as the ICS is not detected by the
Controller and cannot send the LED signals.
This will make it difficult to know when the
imaging process has completed.
5.4.4 FFC INSTALLATION
Forward Facing Camera (FFC)
Image