User Manual

Guardian Field Support Manual – Section 2
62
Tick the Health and Safety Agreement,
which confirms that you have conducted a
Health and Safety Check prior to
commencing the installation. You will not be
able to continue until you have accepted this
agreement.
Click ‘Continue’ to move to Step 2.
Step 2 – Config and eJSON Upload
During this step, you will load the Client’s
configuration file and the eJSON file (both
you will have received in the SW package
prior to arriving at site). This is the required
method for all new installations.
- If you do not have the client specific
configuration file, choose to use the
default configuration file by selecting
“No”.
- If you do not have the eJSON file,
you will not be able to complete this
step, Call SM Support to have this
file sent to you
To load the client configuration file, click
“Yes”. You will then be required to upload
the Custom Configuration file.
2.2 - Using the ‘Browse’ function, locate the
Configuration File on your laptop (you
should have placed this on your Desktop
prior to commencing the Installation). The
configuration file will be named
ivsconfig.xml. Note: the configuration file
will be an .xml file.
Once you have located the file, click on the
‘upload’ button.
2.3 - When the configuration upload has
finished, you will see a green tick and a
statement that says, ‘Custom Configuration
Updated’.
2.4 – Load the eJSON file under
‘Authentication Endpoint Configuration’.
Select ‘Browse’ and locate the eJSON file on
your laptop. Note: the file will end with
‘.ejson’.
Load Configuration File:
Default Configuration and eJSON File: