User Manual

Guardian Field Support Manual – Section 2
66
“Save Configuration” and select ‘System
Reboot’. The system will take approx. 2
minutes to reboot.
Once the reboot has completed, proceed to
the next step.
If a Mix Integration cable is not installed,
move directly to the next step.
6.3 Third Party Event Relay Signal
If a Cruise Control Disable Cable is installed,
the cruise control can be disabled by the
triggering of any of the events listed on this
page. The requirement for enabling or
disabling these settings will come from the
party coordinating the installation.
Once all changes have been submitted as
desired, select “Save Configuration”
Select Save and Continue
Third Party Event Relay Signal:
Step 7 – ICS Setup, Tracker Calibration,
and Test Event Creation
Using real time system feedback, this step
allows you to configure the Camera Pitch
and Yaw, create test events, and verify the
in-cab alerts are working.
Prior to beginning this test, ensure you are
seated in the Driver’s seat and in view of the
ICS.
7.1 Camera Rotation:
The Guardian system allows the installer to
mount the ICS vertically to allow greater
flexibility for placement. For more
information on the supported installation
positions reference “Mounting the ICS at a
different orientation” (section 5.4.3.) earlier
in this manual.
The ICS can be mounted at a 0°, 90°, 180°,
or 270° based on installation; however,
preference is for 0° or 90° rotation only with
the default set to horizontal (0°). The rotation
setting in the IVS Wizard must match the
actual physical rotation of the ICS.
Landing Page: