User Manual

Guardian Field Support Manual – Section 2
68
7.2 Camera ICS Angle (Pitch and Yaw)
There are two ways to set the camera:
1. Using the Auto Calibration function
(preferred).
2. Using the sliders for Pitch and Yaw
(can be used if the Auto Calibration
is not functioning properly).
1. Using Auto Calibration to set Pitch and
Yaw
Using the button ‘Configure Suggested ICS
Angles’, select ‘Start’.
You will be prompted to get into a typical
driving position (facing the road) and given 5
seconds to get steady. After this time, you
will hear one beep indicating the start of the
auto configuration.
After a period of about 2-3 seconds, you will
hear another audible prompt indicating the
auto calibration has ended. Your results will
be now be displayed in the wizard.
Save these results and validate your new
graph calibration graph readings are as
close to 0 as possible. If necessary, select
‘Repeat’ to start a new auto calibration
reading.
Save and Continue.
Values for pitch are 0 to 35. 0 is eye level
for the driver. Slightly negative may have to
be achieved if you are trying to overcome an
object (i.e. steering wheel). It is acceptable
to put 0 as the value if you have had to
install with a slightly negative pitch.
Prepare for Auto Calibration
Assume typical seated position with head and
eyes on road
Pitch and Yaw Results
Save changes: