Product Manual

Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 phone: [phone] fax: [phone] www.guardianfall.com
Ladder Stability Anchor
Part #: 10808
Compliant with OSHA 1910 and OSHA 1926 regulations.
Custom configurations not available.
Contact customer service for details.
Ladder Stability Anchor functions to secure a ladder
against the structure, and reduce the possibility of the
bottom of the ladder kicking out as a result of transitions
between the ladder and the structure.
Ladder Stability Anchor also functions to reduce possibility of base of ladder slipping as a result of loose
ground or wet surfaces, and prevents knock-over of ladder due to wind or accidental collisions.
Materials: aluminum, polyester, nylon, & Velcro.
Ladder Stability Anchor comes with (1) 24” strap and (1) 36” strap.
1. Extend ladder to desired height, then secure one strap around two adjacent ladder rungs at the
mid-lock section of the ladder. This reduces the potential for accidental separation of ladder sections, as
well as increases overall ladder stability.
2. Place ladder against structure, and ensure it is stable. Ensure fifth rung from top of ladder is level
with roof edge.
3. Climb up to roof eave, and install Ladder Stability
Anchor over roof eave. Turn T-clamp until hand tight.
4. Clip remaining strap to Ladder Stability Anchor,
then secure strap around ladder rung.
When storing straps, fold rough side against
rough side. This will stop excessive wear of Velcro.
Replace straps if functionality of Velcro is
noticeably diminished.
User must inspect Ladder Stability Anchor prior to
each use. Competent Person must inspect Ladder
Stability Anchor at least every 6 months.
UPC-A Code: 672421108087