Item Brochure

Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 phone: [phone] fax: [phone] www.guardianfall.com
Friction Fit Bracket
Part #: 15026
Compliant with all OSHA 1910 & OSHA 1926 Subpart M regulations.
Friction Fit Bracket is suitable for the following applications:
Custom configurations not available. Not repairable.
Contact customer service for details.
Fall Prevention: Friction Fit Bracket may be used in Fall
Prevention applications ONLY. Fall Prevention Systems are
placed around the leading edges of any and all fall hazards to prevent a worker from
going over an edge, and may be used in substitute of Fall Protection or safety netting
systems. Installation requirements for Friction Fit Bracket set forth in this manual MUST be
adhered to. Personal Fall Arrest, Work Positioning, Climbing, Rescue, and any other
systems must NEVER be connected to Fall Prevention Systems.
!
WARNING
Use of equipment in unintended applications may result in serious
injury or death. NEVER make any connections to guardrail systems.
Materials: zinc-plated steel.
Surfaces more than 6’ above lower levels require the use of a Fall Prevention or Fall Protection system.
Friction Fit Brackets may be placed a MAXIMUM of 8’ apart.
Installation location MUST be deemed compatible with Friction Fit Brackets by a Competent Person.
Friction Fit Brackets MUST be installed flush against substrate, and must allow guardrail posts to be
positioned perpendicular to work surface.
All guardrail posts, guardrails, and all other equipment
must be selected and deemed compatible by a
Competent Person. All guardrails MUST be compatible
2” x 4“ or 2” x 6“ construction grade lumber, or
compatible snap-on metal rails.
UPC-A Code: 672421150260.