Item Brochure

Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 phone: [phone] fax: [phone] www.guardianfall.com
G-Rail System
Materials: powder-coated steel or galvanized steel.
Compliant with all OSHA 1910 and OSHA 1926 Subpart M regulations.
G-Rail System is suitable for the following application:
# 15178
# 15180
# 15184/15185
ALWAYS assemble and use G-Rail System according to instructions provided with equipment
by the manufacturer.
Part # Size Description
15178
15180
15181
15182
15183
15185
15184
42”H x 10’L
42”H x 6’L
42”H x 8’L
10”L
22”L
Long Toeboard Attachment
Short Toeboard Attachment
6’ Guardrail
8’ Guardrail
10’ Guardrail
QuickSet Multi-Directional Baseplate
Baseplate
10”W x 30”L
21½”W x 21½”L
15202 42”H x 12’L 12’ Guardrail
Fall Prevention: G-Rail System may be used in Fall Prevention applications ONLY.
Fall Prevention System are placed around the leading edges of any and all fall
hazards to prevent a worker from going over an edge, and may be used in
substitute of Fall Protection or safety netting systems. Installation requirements
for G-Rail System set forth in product instruction manual MUST be adhered to.
Personal Fall Arrest, Work Positioning, Climbing, Rescue, and any other systems
must NEVER be connected to Fall Prevention Systems.
Toeboards must be 2” x 4” construction grade lumber. Baseplates must be at least 24” from the edge of any opening or
leading edge hazard.
An outrigger is a guardrail installed perpendicular to a continuous run. ALWAYS use outriggers at BOTH ends of any
interruption in a G-Rail System, and at BOTH ends of a continuous G-Rail System. There is no limit on the maximum length
of a continuous G-Rail System.
MAXIMUM permitted roof pitch is 1/12 (5°).
# 15181/15182/15183/15202
21”
42”
Ø: 1.66”