User's Manual
PARTS & FUNCTION DOOR BELL
MOUNTING & POWER
3
Flasher
Indicator
Function
switch
Speaker
Melody
button
Learn
button
Wall plug
(AC plug)
This receiver work with AC 80V to 240v, do not need any install.
Simply plug to the AC wall socket.
This receiver can handle two wireless doorbell buon or transmier with
different melody and flash paern.
First, press & hold the ● zone selector button for 3 seconds to
enter the pairing mode. Press the ♫ melody selector button to
select the melody desired.
Trigger transmitter once to record the melody
CODE PAIRING & MELODY SELECTION
Clearing the transmitter memory of the Receiver
Change the melody
* PLESE NOTE THE DOORBELL BUTTON & CHIME UNIT ARE
PAIRED & READY TO USE.
Step1: I n s e r t t h e b a t t e r y i n t o t h e
transmitter to be used (Doorbell
button)
Step 2: Plug the receiver to the wall
socket.
Step 3: Press & hold the ● learn button
for 3 seconds. The red LED
indicator inside the lens will
blank.
(if the red LED indicator will lit
constant. Indicates the memory
is full. )
Step 4: Press the ♫ melody selector
button to scroll through the melodies. Once you hear a
melody you prefer, do not press any button as the
melody is set for that transmitter.
Step 5: Once the melody are selected, Trigger the transmitter
to pair. If successful, the receiver (chime unit) will
generate a short tones. Press the ● zone selector
button to exit the pairing mode, the system is now
ready to use.
First, press & hold the ● learn button for 3 seconds to enter the
pairing mode. Press & hold the ● learn button & ♫ melody
selector button together for 3 seconds to delete the memory.
The receiver will generate a beep tone to indicate all transmitter
on the memory is deleted. The red LED will change to blink. Now
you can pair new transmitter to the receiver.
Melody
Learn
USER MANUAL