Installation Manual

How to install the Radascan System
Unpacking the Radascan System
The whole Radascan system is supplied and shipped in a custom-built crate, Use the following
procedure to unpack and prepare the Radascan System.
To unpack the Radascan System
1. Position the Radascan crate on a level surface, close to the area where the sensor will be
installed.
2. Remove the top panel and then the side panels from the crate.
3. Remove the securing bolts (M12) from the base of the Radascan system.
Mounting the Radascan Sensor
To be specified
Radascan Installer – 6