Installation Manual

Location offsets (requires service access)
Location offsets allow you to define exactly where, within the outline of the vessel, the Radascan
sensor is positioned. The location offsets are expressed as four values (length and breadth of the
vessel, plus a bow offset and a starboard offset) held with the Configuration page tab of the
property sheet.
To adjust the location offsets
1 Enter Service Access mode using either an engineer’s USB key or a temporary service access
code.
2 View the Configuration page tab within the Property sheet
.3 Click the down arrow of the Select Configuration Category box and select the Vessel
Parameters / File Transfer option.
4 In the Length and Breadth fields, enter the overall size of the vessel.
5 In the Bow Offset and Starboard Offset fields, enter the distance of the sensor from the bow
and from the starboard side, respectively.
6 Click the Apply button.
Radascan
Installer – 13