Installation Manual

Bearing offset (requires service access)
The Bearing offset allows you to optionally correct any deviation of the Radascan sensor’s
centre-line from that of the vessel’s.
The bearing offset is calculated based on the direction of the Radascan sensor relative to
the bow - irrespective of whether the sensor is mounted with its connectors facing the bow or
the stern.
To adjust the bearing offset
1 Enter Service Access mode using either an engineers thumb key or a temporary service
access code.
2 View the Configuration page tab within the Property sheet.
3 Click the down arrow of the Select Configuration Category box and select the Vessel
Parameters / File Transfer option
Radascan Installer – 17