Instruction Manual

After Sales Helpline 03303 800 661

General Operation

DRY & WET VACUUM OPERATION

WARNING: ENSURE YOU READ, UNDERSTAND AND APPLY SECTION ENTITLED

‘SAFETY INSTRUCTIONS & WARNINGS’.

WARNING: DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPOURS,

OR EXPLOSIVE DUSTS IN THE AIR. DO NOT VACUUM HAZARDOUS SUBSTANCES.

FLAMMABLE GASES OR VAPOURS INCLUDE BUT ARE NOT LIMITED TO; LIGHTER

FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, ALCOHOL

OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;

COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH

HAZARDS FROM VAPOURS OR DUST, DO NOT VACUUM TOXIC MATERIALS.

1. Verify that the power cord is disconnected from the power socket (Fig. 1).

2. Choose the desired filter for dry or wet vacuuming following the instructions listed below.

3. After installing the filter, place the power head back on the container securing the

latches on either side of the container.

4. Insert the locking end of the hose into the vacuum port and lock in place (Fig. 2).

5. Choose the desired accessories and extension wands and push the attachment(s) onto

the hose nozzle (Fig. 3).