Instruction Manual

10
After Sales Helpline 03303 800 661
General Operation
SWITCHING ON/OFF
Connect the mains plug to a suitable a power outlet.
Position I switches the vacuum cleaner on for normal operation.
Position II switches the vacuum cleaner onto standby mode for automatic synchronized
start-up when used with an attached power tool (not supplied).
Position O switches off the vacuum cleaner (middle position).
POWER TOOL TAKE-OFF OPERATION
WARNING: Always check the maximum wattage compatibility of the power tool take
off socket on the vacuum cleaner against the desired power tool before connecting.
This may render the machine unusable if the maximum wattage is overloaded.
1. Connect the power cable of your power tool to the power take-off socket on the vacuum.
2. If applicable, connect the vacuum suction hose to the dust extractor connector on your
tool with the supplied adaptor. Check that the connections are secure and air-tight.
3. Set the switch on the wet and dry vacuum cleaner to position II, as described in
Switching ON/OFF. The moment you switch on the power tool, the vacuum cleaner will
also switch on.
Once the electrical appliance has been switched off, the vacuum cleaner switches off
following a time lapse (around 5 seconds) to allow the suction tube to be emptied.
Position Status
I on
O off
II automatic synchronized start-up
1 2
3 4
MAX POWER: 1400W