Instruction Manual

13
After Sales Helpline 03303 800 661
7 8
9 10
FOR DRY VACUUMING:
WARNING: BEFORE INSTALLING, REMOVING OR CLEANING THE VACUUM
CLEANER FILTER, ENSURE THAT THE POWER CORD IS REMOVED FROM THE
POWER OUTLET AND THE APPLIANCE IS SWITCHED OFF.
1. In order to prepare your vacuum cleaner for dry vacuuming, verify that the cartridge
filter is securely mounted. If the cartridge filter is not installed, follow the instructions
listed below.
2. Optionally, for improved dust filtration, fully fit the dust bag flange onto the inlet stub,
taking care not to damage the bag. The Vacuum cleaner can we be used with or without
dust bags.
3. Remove the power head and place in an upside down position.
4. Install the cartridge filter over the filter cage with the flat end of the filter towards the
vacuum power head. Carefully push filter until it sits flush against the power head
forming a tight seal (Fig. 7 & 8).
5. Place the filter retainer cap on top of cartridge filter over the raised lip and tighten by
turning the retainer lock clockwise to secure against the internal filter cage (Fig. 9 & 10).
IMPORTANT: Check the filter regularly for optimal performance. An old or blocked filter
will reduce suction performance.
General Operation
Note: Make sure
the raised lip
on the cartridge
filter is
positioned away
from the power
head.