Instruction Manual

After Sales Helpline 03303 800 661

11 12

General Operation

FOR WET VACUUMING:

WARNING: BEFORE INSTALLING, REMOVING OR CLEANING THE VACUUM

CLEANER FILTER, ENSURE THAT THE POWER CORD IS REMOVED FROM THE

POWER OUTLET AND THE APPLIANCE IS SWITCHED OFF.

1. In order to prepare your vacuum cleaner for wet vacuuming, remove the power head

from the container and place in the upside down position (Fig. 11).

2. Remove the retainer cover and the dry use cartridge filter.

3. Carefully install the supplied foam filter over the internal filter cage, making sure the

whole cage is covered (Fig. 12).

WARNING:

DO NOT USE THE CARTRIDGE FILTER FOR WET VACUUMING

DO NOT USE A DUST COLLECTION BAG FOR WET VACUUMING

IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle

completely in the liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The

machine is fitted with a float valve that stops the suction action when the container reaches

its maximum capacity. You will notice an increase in motor noise. When this happens,

turn off the machine, disconnect from power supply, and drain the liquid into a suitable

receptacle or drain. To continue vacuuming, replace the drainage cap. After wet vacuuming,

turn off the machine and remove the plug from the power supply. Empty the container,

clean and dry inside and outside before storage.

REMEMBER! The foam filter must be removed after wet vacuuming and the reusable

cartridge filter must be reinstalled before dry vacuuming again.