Instruction Manual

8
After Sales Helpline 03303 800 661
4
6
5
Inlet Stub
Vacuum Port
4. Insert the carry handle into the slots located on the top of the power head, and secure
with the screws provided. Do not over-tighten the screws (Fig. 4).
5. With the power head removed, turn the container upside down. Insert the feet with
casters into the slots and apply pressure until they click into place, and secure them
with supplied screw. Do not over-tighten the screws (Fig. 5).
6. Your vacuum cleaner comes ready for dry vacuum cleaning with the cartridge filter
pre-installed. If the cartridge filter is not installed, refer to page 13 for filter installation
instructions.
7. Optionally, for improved dust filtration, fully fit the dust bag flange onto the inlet stub,
taking care not to damage the bag (Fig. 6).
General Assembly