Instruction Manual

Customer Helpline 0333 3201989
12
NOTE: Before using the tool, read the instruction book carefully.
Intended Use
This tool is intended for grinding, polishing metal as well as for cutting metal and drilling
in metal and wood.
1. CHANGE THE COLLET (SEE FIG A)
Three size of collets are provided to accommodate the different accessories shank sizes.
When using an accessory with a smaller or larger shaft, you will need to change the collet
which matches the shank size of the accessory as follows.
Press the spindle lock button. Loosen the collet nut (1) with the spanner provided. Remove
the collet nut (1) and then fully insert the appropriate size collet (7) into the spindle.
Reinstall the collet nut (1) by finger tight. Do not over-tighten the nut when there is no
accessory in the collet.
WARNING! Fully tighten the collet nut before operation.
Always use the collet which matches the shank size of the accessory you plan to
use. Do not force a larger diameter shank into a smaller collet.
2. FITTING AN ACCESSORY (SEE FIG B, C)
Press the spindle lock button. Hold down and rotate the spindle by hand until the spindle
lock engages with the spindle. Loosen the collet nut anti-clockwise using the spanner if
necessary.
Fully insert the tool shank into the collet. Tighten the collet nut with the spanner but do
not over-tighten. Finally release the spindle lock button.
WARNING: Do not engage the spindle lock button while the tool is running.
Operating Instructions
o
I
1 2
1
2
3
1
2
1
7
11
29
a
f
6mm(1/4')
e
d c
a
b
1
2
A B
C D
E F
G1 G2
G3
H I
J K
L M
N