Instruction Manual

Customer Helpline 0333 3201989
15
Operating Instructions
6. CONNECT THE FLEXIBLE SHAFT TO THE TOOL (SEE FIG H)
WARNING: Never bend the flexible shaft with a radius of less than 152mm when
operating. Always store the flexible shaft carefully to avoid sharp bends when not
in use.
1). Depress spindle lock button (2) and unscrew counter-clockwise the collet nut (1) and
plastic ring (a) from the spindle.
2). Remove the collet from the spindle socket (b).
3). Insert the inner shaft (c) of flexible shaft into the spindle socket (b) until the bump (d)
touches the spindle socket.
4). Screw clockwise the fixed ring (e) of flexible shaft onto housing thread.
5). Tighten the fixed ring (e) by hand. Do not use pliers or spanner.
7. REPLACE THE COLLET & ACCESSORIES ONTO FLEXIBLE SHAFT (SEE FIG I)
1). Rotate the collet of flexible shaft until the hole on the shaft is aligned with the hole
(f) of the flexible shaft collar, insert the locking pin (29) to lock the inner shaft (c) and
then unscrew counter-clockwise the collet nut by supplied spanner (27).
2). Fit accessory to spindle socket of flexible shaft through appropriate size collet
(7). Keep locking pin to lock the inner shaft (c), tighten clockwise the collet nut by
spanner.
WARNING! Fully tighten the collet nut before operation. Always use the collet
which matches the shank size of the accessory you plan to use. Do not force a
small diameter shank into a large collet.
WARNING! Do not attempt to loosen or tighten the collet without locking the
shaft as noted above. Damage to the flexible shaft will result.
o
I
1 2
1
2
3
1
2
1
7
11
29
a
f
6mm(1/4')
e
d c
a
b
1
2
A B
C D
E F
G1 G2
G3
H I
J K
L M
N