Instruction Manual

Customer Helpline 0333 3201989
17
Using Accessories
The chart below lists the description, use speed and scope for some of the small articles
supplied together with the tool by category. To achieve best performance of the tool, it is
strongly recommended that you read it prior to operation, failure to adhere to this may
cause accessories to fail.
NOTE: ALWAYS Wear eye protection Insert the shaft FULLY into the collet. Use ONLY up
to the speeds stated below.
PICTURE DESCRIPTION SPEED FOR USE ON
Grinder bits
Various head styles,
on shafts
Full speed
32,000/min
Metal
Mild steel
Diamond Bits
Various head styles
Full speed
32,000/min
Wood Zinc
Plastic Nickel
Copper Mild steel
Wool Wheel
Mounted to screw drill
Half speed
16,000/min
Metal
Mild steel
Sanding/Cutting wheels
Mounted to cutting wheel
fixture
NOTE:
DO NOT over tighten screw
Half speed
16,000/min
Metal
Mild steel
Wood
Sanding Roll
Mounted on hold for rubber
wheel
Full speed
32,000/min
Metal
Mild steel