Instruction Manual

Customer Helpline 0333 3201989
18
WARNING: Remove the plug from the socket before carrying out any adjustment,
servicing or maintenance.
REPLACING THE CARBON BRUSHES (SEE FIG L, M, N)
The carbon brushes must be checked on a regular basis. There are two brushes in the tool
and they must be replaced in pairs.
Remove the carbon brush holders with the spanner and check the brushes. If the length of
brush is less than 6mm, replace both brushes. Have the tool run at no load for 15 minutes.
NOTE: Use only the correct type of carbon brushes.
CAUTION: Using the tool with worn brushes (availible from Guild helpline) will
permanently damage the motor.
Maintenance & Trouble Shooting
o
I
1 2
1
2
3
1
2
1
7
11
29
a
f
6mm(1/4')
e
d c
a
b
1
2
A B
C D
E F
G1 G2
G3
H I
J K
L M
N