User's Manual

Foldable Smartphone Gimbal
Quick Start Guide
EN V 1.0
Prohibit any user for any illegal purpose. Users will be responsible for all behaviors of purchase and use products.
The Company assumes no liability for any risks related to or resulting from the debug and use of this product (including the direct,
indirect or third-party losses).
For any unknown sources of using, we will not be at any services.
The updating and changes of product firmware and program may cause changes in function descriptions in this user manual,
please read the instructions carefully before upgrading the firmware and use the corresponding user manual.
You can get the latest user manual from the official website: www.feiyu-tech.com
FeiyuTech reserves the right to amend this manual and the terms and conditions of use the gimbal at any time.
D I S C L A I M E R
Overview
Folded status Unfolded status
1. Fold and unfold
(1) Loosen the folding knob and tighten the knob after unfolding the
vertical arm.
(2) Unlock the three axis clamp.
(1) Lock the three axis clamp.
(2) Loosen the folding knob, and then tighten the knob
after folding the vertical arm.
User Guide
VLOG pocket is a three-axis handheld gimbal suitable for mobile phones. It is small and
foldable which can be folded into a pocket. The gimbal supports landscape and portrait
shooting, which can also control phone shooting.
iOS Version Android Version
* Requires iOS 9.0 or later, Android 6.0 or later.
Download the Feiyu ON App
Specifications
Adapter
smartphones
IPhone and Android phones
Payload 240g
Weight 272g
( Not including the smartphone )
Operation Time 5~8 Hours
Max. Tilting Range 240°
Max. Rolling Range
165°
Max. Panning Range 330°
( The width of the phone is between 42~88mm )
For More
Operation TutorialDetailed Manual More Downloads
It is recommended to remove the protective cover of the smartphone before installation
and keep the extend port of the smartphone holder facing down.
3. Camera Installation
5. Landscape and portrait shot switching
Double click the function button to switch modes between landscape and portrait.
4. Power on / off
Turn on the smartphone only after it is installed securely.
Unlock the three axis clamp before powering on the gimbal.
Long press the function button and release it
when you hear the tone.
(Green light will change to blue)
Double
click
Keep the extend
port facing down
Power on :
Long press the function button and release it
when you hear the tone. (The red light will turn off)
Power off :
Double
click
Long
press
Keep the smartphone
in center
(1) Please fully charge the batteries before powering on the gimbal for the first time.
(2) If the power is too low, the red light will flash three times every five seconds, indicating
you should charge it immediately.
(3) When not in use, turn off the gimbal.
(4) Unlock the three clamp before powering on the gimbal.
(5) Landscape to install the phone.
TIPS
12
13
9
14
17
16
10
18
1
2
5
13
4
11
8
3
15
6
7
X1X1
TripodMicro-USB Cable
*This product does not include the smartphone
13. Pan axis clamp
5. Tilt axis 17. Extend port11. Roll axis clamp
16. 1/4 inch thread hole4. Roll axis 10. Smartphone holder
1. Function button
14. Micro-USB port8. Vertical arm2. Shutter button
9. Folding knob3. Shortcut button 15. Handle
12. Tilt axis clamp 18. Status indicator6. Pan axis
7. Cross arm
Unfold
Fold
Unlock / Lock the clamp
Take the pan axis clamp for example.
Unlock state Lock state
2. Charging
Connect the USB cable to charge. The indicator
light is red when charging, and green when fully
charged.
For more information, please visit our official website: www.feiyu-tech.com
Due to software and hardware improvements, your actual product might differ
from the descriptions and pictures in this user manual. You can get the latest
user manual from the official website.