User guide

- 6 -
Locating the Battery Tray Kit
The battery tray is located on the left hand
side of the compartment. Gently pull back the
foam cover and remove the two thumb screws
located at both ends.
Disconnect the power cable from the battery
tray and remove from the safe.
Loading the Battery Tray
Make sure that the ends of each battery match the positive (+) and negative (-) marking in the tray
exactly. Make sure that the batteries are not loose.
Installing the Battery Tray in the Safe
• Connect the power cable to the battery tray. You will hear a beep audio signal, confirming that
power is connected.
• Do not pinch the power cable between the tray and the side.
• Press the tray into position, aligning the slots/holes onto the mounting studs.
• Use the thumb screws to secure the tray.
• Do not over-tighten the fasteners; snug is best.
• Press the foam back into your unit to cover the battery tray and tuck in the far end to secure it.
(HV3000)
IMPORTANT: We recommend that you use ONLY Duracell AA batteries. Eight (8) AA batteries
are required. NEVER attempt to use rechargeable batteries – they will not work!
Continued on Page 8 – 4. Getting Ready to Program