Use and Care Manual

LP Lock

(top row of numbers are 1,2,3 with the letter ‘A’ on the number ‘1’)

1. Opening the Safe

Important: The factory preset code is 1,2,3,4,5,6 and should be changed before using the safe. It is the owners’

responsibility to maintain the code; Cannon will try to maintain records for up to 6 months. Multiple electronic

locks are used, each with different operating instructions.

See the ‘ID My Lock

Step 1: Turn the handle slightly clockwise until handle stops. Do not force!

Step 2: Enter the six (6) digit code slowly.

Step 3: Turn handle counter-clockwise immediately after the two (2) beeps to unlock safe.

’ section before beginning (Pg 4).

If there is one (1) long beep after entering the code the lock doesn’t recognize the code. Slow down and start

over.

2. Programming Instructions

Important: When changing the combination, door must be in the open and locked position. On some safe models

there is a detent release on the bottom of the door that must be pushed up to put door into locked position. You

must know the current six (6) digit code to program and have 20 seconds to complete steps 1-4.

Step 1: Press and hold '0' until double beep. The LED remains on during the following actions

Step 2: Enter existing six (6) digit code - You will hear a double beep

Step 3: Enter new six (6) digit code - You will hear a double beep

Step 4: Re-enter new six (6) digit code - You will hear a double beep

If lock gives a long beep the old code is still valid.

3. Lock Out (Wrong Try Penalty)

After four (4) wrong entries the lock will go into lock out for 5 minutes. Lock can also go into lock out during re-

programming if it interprets an incorrect programming sequence.

Do not press any buttons or unplug the battery during the lockout period.

It will restart the 5 minute waiting period.

4. Maintenance

Important: All maintenance work should be performed by a qualified locksmith in your area. Cannon assumes no

responsibility for the cost of maintenance or the work performed.

Low Battery Warning: The lock will repeatedly beep during unlocking indicating that the battery is low and needs

to be replaced. Only use Duracell Alkaline batteries with a ‘Best if Used by Date’ 5 years in the future.

Changing the Battery: To replace battery locate the sliding door on the bottom of the keypad. Slide door over and

battery will drop out.

74306-Cannon_Safe_Text-r4.indd 8 2/22/11 9:39:31 PM