Use and Care Manual

S&G Electronic Lock
(#1 key on the keypad has the letter ‘Q’)
1. Opening the Safe
Important: The factory preset code is 1,2,3,4,5,6,# and should be changed before using the safe. It is the owners’
responsibility to maintain the code; Cannon will try to maintain records for up to 6 months. Multiple electronic
locks are used, each with different operating instructions.
See the ‘
ID My Lock
Step 1: Turn the handle slightly clockwise until handle stops. Do not force!
Step 2: Enter the six (6) digit code slowly, then #.
Step 3: Turn handle counter-clockwise to unlock safe.
’ section before beginning (Pg 4).
If there’s a long brap (beep) after entering the code the lock doesn’t recognize the code. Slow down and start
over.
2. Programming Instructions
Important: When changing the combination, door must be in the open and locked position. On some safe models
there is a detent release on the bottom of the door that must be pushed up to put door into locked position. You
must know the current six (6) digit code to program and have 20 seconds to complete steps 1-4.
Step 1: Press 7 4 * (existing code) # - There will be 5 beeps.
Step 2: Press 1 *
Step 3: Enter new six (6) digit code # - There will be 3 beeps.
Step 4: Re-enter new six (6) digit code # - There will be 3 beeps.
If the lock signals a long brap (beep) the old code is still valid.
3. Lock Out (Wrong Try Penalty)
After four (4) wrong entries the lock will go into lock out for 15 minutes. Lock can also go into lock out during re-
programming if it interprets an incorrect programming sequence.
Do not press any buttons or unplug the battery during the lockout period.
It will restart the 15 minute waiting period.
4. Maintenance
Important: All maintenance work should be performed by a qualified locksmith in your area. Cannon assumes no
responsibility for the cost of maintenance or the work performed.
Low Battery Warning: The lock will beep twenty (20) consecutive times after the last number of the combination
is entered. Only use Duracell Alkaline batteries with a ‘Best if Used by Date’ 5 years in the future.
Changing the Battery: On bottom of the face plate remove the tape with the red tab and locate the trap door;
push up slightly and slide forward. Battery tray will drop straight down. Attach new battery, slide into opening,
and replace trap door by pushing up slightly and sliding back.
6
74306-Cannon_Safe_Text-r4.indd 6 2/22/11 9:39:29 PM