Where Quality & Power Meet 10 Quart Back Pack Vacuum OWNERS MANUAL IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: 1
READ ALL INSTRUCTIONS BEFORE USING. ! WARNING-to reduce the risk of fire, electric shock, or injury: 1. Do not leave appliance unattended when plugged in. Unplug from outlet when not in use and before servicing. 2. Do not use outdoors or on wet surfaces. 3. Do not try to recover any liquid with this vacuum. This vacuum is for DRY RECOVERY only. 4. Do not allow to be used as a toy. Close attention is necessary when used by or near children. 5. Use only as described in this manual.
GV 10 Quart Vacuum Diagram 1. Filter guard A 2. HEPA Filter 3. Filter guard B 4. Motor 5. Thermo-protector (not provided) 7. Cover latch A 8.switch 9.Screws(M3*25) 7a. Screws 11.Upper part of switch box 12. Connector terminal and insulator sets 14. Wire connector soldering log box 16.Connection cable 10. Screws(M3*15) 13. Power supply cords and cord 14.1. Wire connector soldering log 17. Connection cable fixer nut 6. Extension Cord 15. Lower part of switch 18.
INSTALLATION AND OPERATIING INSTRUCTION INSPECTION Carefully unpack and inspect your new vacuum for shipping damage. each unit is tested and thoroughly inspected before shipping. ! WARNING DO NOT vacuum with a frayed, worn, or damaged cord. DO NOT vacuum liquids or expose the backpack vacuum to rain or water. DO NOT vacuum hazardous or toxic materials. DO NOT use to pick up flammable or hazardous material GROUNDING INSTRUCTIONS This appliance must be grounded.
motors must never be used in application in which wet or moist conditions are involved, where dry chemicals or other volatile materials are present, or where airflow may be restricted or blocked. Such motors are designed to permit the vacuumed air to pass over the electrical wiring to cool it. Therefore, any liquid, dry chemical, or other foreign substance which could come in contact with electrical conductors could cause combustion(depending on volatility) or electrical shock..
completely and tightly (Figure C). 6. Check the hose ends to make sure that they are tightly fixed. In the event a hose end comes apart from the hose the hose can simply be rethreaded into the hose end. 7. Check the wear on the cord by the vacuum body and at the plug. Pass the power supply cord (No.13) through the strip outside the left side of the waist belt.( Figure E). 8. Fix the switch box (No.11 and No.15) under the sewn strap and knot the other strap around the switch box.
12. Attach tools to the handle and make sure the two ends are tightly connected. (Figure I) PROPER VACUUMING MOTION FOR LARGE AREA WITH DIRECT SUCTION TOOLS 1. Begin with the wand parallel to your body. 2. Draw the top of the wand in towards your waist and twist at the waist walking back and forward (a side-to-side motion). 3. The motion is similar to mopping and keeps the upper body and arms from tiring.
PROPER STORAGE When the vacuum is not in use, it should be stored in a dry place ELECTRICAL CORD CARE NEVER stretch the cord tightly between the vacuum and the outlet. A cord that is stretched or pulled will not function properly and creates a danger. After vacuuming, unplug the cord and wind it up loosely . DO NOT wind the cord up by wrapping it around your hand and elbow. CARING FOR YOUR VACUUM 1. Every time you finish vacuuming, shake out the cloth and Paper dust bags (No.31 and No.32). 2.
c. Put the round rubber support (No.22) into the canister to support the foam filter from falling down. Warranty Information – Your GV 10 Quart Back Pack Vacuum is protected by the 3 year Residential Manufacturer motor warranty (1 Year Commercial Manufacturer motor warranty) and a 1 year bumper to bumper warranty. Warranty does not cover filters which will need to be replaced from time to time depending on use.